Salesforce

ZPL ~JD Hex or ASCII Dump Command Details

Printable View
« Go Back

Information

 
Issue / QuestionA user might need to use a ZPL command to put the printer into Hex Dump mode.
I don't have a display. How do I enable hex dump mode?
Applicable To​Zebra Printers that support ZPL

Excludes: 2824 Series, 2844 Series, S4M (E53 Firmware Version), 888 DD/TT Series, MZ Series, ZQ110, EM220, EM220II
Resolution / Answer

The ZPL command "~JD" will cause the printer to print the received data sent via the port it was received.

Note: If using the command over a Network you must send the expected data from the same connection. You cannot enable the hex dump and then send data from a different port or connection.

See the ~JD command for details Read More>>

To turn off your Hex Dump use ~JE Read More>> 

 

Source

ZPL Manual
URL NameZPL-JD-Hex-or-ASCII-Dump-Command-Details
TitleZPL ~JD Hex or ASCII Dump Command Details
Powered by