How to manually calibrate the ribbon and media sensors on the ZT230 printers so the label stops at the correct spot between two labels?
Applicable To
ZT230 Industrial Printer
Resolution / Answer
Watch this step-by-step video to learn how to manually calibrate the ribbon and media sensors on the ZT230 Industrial Printer.
If the printer fails to detect the media size correctly, you may have to manually calibrate the ribbon and media sensors.
Calibration is not required if the label stops at the tear-off point between two labels, and when you press FEED, one label feeds to the next tear-off.
Calibration of the printer will not resolve an issue where it stops correctly at the tear-off point and can feed one label at a time. Still, the print is being shifted Up/Down or Left/Right from where it should be printed on the label, and this issue requires a print driver or ZPL adjustment to correct the shifted print.